Act now and download your Cisco 200-101 test today! Do not waste time for the worthless Cisco 200-101 tutorials. Download Refresh Cisco Interconnecting Cisco Networking Devices Part 2 (ICND2) exam with real questions and answers and begin to learn Cisco 200-101 with a classic professional.
2021 Jun primes 101-200:
Q11. Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms?
D. Frame Relay
Q12. After the network has converged, what type of messaging, if any, occurs between R3 and R4?
A. No messages are exchanged.
B. Hellos are sent every 10 seconds.
C. The full database from each router is sent every 30 seconds.
D. The routing table from each router is sent every 60 seconds.
Q13. Refer to the exhibit.
At the end of an RSTP election process, which access layer switch port will assume the discarding role?
A. Switch3, port fa0/1
B. Switch3, port fa0/12
C. Switch4, port fa0/11
D. Switch4, port fa0/2
E. Switch3, port Gi0/1
F. Switch3, port Gi0/2
Q14. Which type of EIGRP route entry describes a feasible successor?
A. a backup route, stored in the routing table
B. a primary route, stored in the routing table
C. a backup route, stored in the topology table
D. a primary route, stored in the topology table
Q15. R1 is configured with the default configuration of OSPF.
From the following list of IP addresses configured on R1, which address will the OSPF process select as the router ID?
Up to the minute composite numbers 101-200:
Q16. Refer to the exhibit.
The Lakeside Company has the internetwork in the exhibit. The administrator would like to reduce the size of the routing table on the Central router. Which partial routing table entry in the Central router represents a route summary that represents the LANs in Phoenix but no additional subnets?
A. 10.0.0.0/22 is subnetted, 1 subnets D 10.0.0.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1
B. 10.0.0.0/28 is subnetted, 1 subnets D 10.2.0.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1
C. 10.0.0.0/30 is subnetted, 1 subnets D 10.2.2.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1
D. 10.0.0.0/22 is subnetted, 1 subnets D 10.4.0.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1
E. 10.0.0.0/28 is subnetted, 1 subnets D 10.4.4.0 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1
F. 10.0.0.0/30 is subnetted, 1 subnets D 10.4.4.4 [90/20514560] via 10.2.0.2, 6w0d, Serial0/1
Q17. Refer to the exhibit.
The network is converged. After link-state advertisements are received from Router_A, what information will Router_E contain in its routing table for the subnets 184.108.40.206 and 220.127.116.11?
A. O 18.104.22.168 [110/13] via 22.214.171.124, 00:00:07, FastEthernet 0/0 O 126.96.36.199 [110/13] via 188.8.131.52, 00:00:16, FastEthernet 0/0
B. O 184.108.40.206 [110/1] via 220.127.116.11, 00:00:07, Serial 1/0 O 18.104.22.168 [110/3] via 22.214.171.124, 00:00:16, FastEthernet 0/0
C. O 126.96.36.199 [110/13] via 188.8.131.52, 00:00:07, Serial 1/0 O 184.108.40.206 [110/13] via 220.127.116.11, 00:00:16, Serial 1/0 O 18.104.22.168 [110/13] via 22.214.171.124, 00:00:16, FastEthernet 0/0
D. O 126.96.36.199 [110/3] via 188.8.131.52, 00:00:07, Serial 1/0 O 184.108.40.206 [110/3] via 220.127.116.11, 00:00:16, Serial 1/0
Q18. What are two drawbacks of implementing a link-state routing protocol? (Choose two.)
A. the sequencing and acknowledgment of link-state packets
B. the requirement for a hierarchical IP addressing scheme for optimal functionality
C. the high volume of link-state advertisements in a converged network
D. the high demand on router resources to run the link-state routing algorithm
E. the large size of the topology table listing all advertised routes in the converged network
Q19. What command is used to verify the DLCI destination address in a Frame Relay static configuration?
A. show frame-relay pvc
B. show frame-relay lmi
C. show frame-relay map
D. show frame relay end-to-end
Q20. What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is in active status?
A. It routes all traffic that is addressed to the destination network to the interface indicated in the routing table.
B. It sends a copy of its neighbor table to all adjacent routers.
C. It sends a multicast query packet to all adjacent neighbors requesting available routing paths to the destination network.
D. It broadcasts Hello packets to all routers in the network to re-establish neighbor adjacencies.