You will obtain instant accessibility to Pass4sure Cisco 200-120 practice questions along with answers. Make entire use of your valuable 200-120 study materials along with be on the road towards Cisco Cisco certification. You will always be very proud from the Cisco 200-120 certificate and get the satisfactory job inside IT industry. Pass4sures experts have constantly revise along with update the Cisco Cisco 200-120 exam dumps. There are some adjustments to the Cisco true exam every yr. Our examination makers will figure out the latest changes along with renovate our Cisco Cisco exam merchandise. We guarantee that every single candidate will pass your Cisco 200-120 real examination with the help of the Cisco 200-120 Pdf questions and answers. Or else, you can claim your full refund or even another Cisco Cisco product without virtually any fees inside the same price if you fail.

2021 Nov testinside 200-120:

Q41. - (Topic 2) 

Refer to the exhibit. 

Which two statements are true about interVLAN routing in the topology that is shown in the exhibit? (Choose two.) 

A. Host E and host F use the same IP gateway address. 

B. Router1 and Switch2 should be connected via a crossover cable. 

C. Router1 will not play a role in communications between host A and host D. 

D. The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces. 

E. Router1 needs more LAN interfaces to accommodate the VLANs that are shown in the exhibit. 

F. The FastEthernet 0/0 interface on Router1 and the FastEthernet 0/1 interface on Switch2 trunk ports must be configured using the same encapsulation type. 

Answer: D,F 


Q42. - (Topic 7) 

Scenario 

Refer to the topology. Your company has decided to connect the main office with three other remote branch offices using point-to-point serial links. 

You are required to troubleshoot and resolve OSPF neighbor adjacency issues between the main office and the routers located in the remote branch offices. 

An OSPF neighbor adjacency is not formed between R3 in the main office and R5 in the Branch2 office. What is causing the problem? 

A. There is an area ID mismatch. 

B. There is a PPP authentication issue; a password mismatch. 

C. There is an OSPF hello and dead interval mismatch. 

D. There is a missing network command in the OSPF process on R5. 

Answer:


Q43. - (Topic 9) 

What is the correct routing match to reach 172.16.1.5/32? 

A. 172.16.1.0/26 

B. 172.16.1.0/25 

C. 172.16.1.0/24 

D. the default route 

Answer:


Q44. - (Topic 7) 

Refer to the exhibit. 

A problem with network connectivity has been observed. It is suspected that the cable connected to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected? 

A. Host B would not be able to access the server in VLAN9 until the cable is reconnected. 

B. Communication between VLAN3 and the other VLANs would be disabled. 

C. The transfer of files from Host B to the server in VLAN9 would be significantly slower. 

D. For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network function would resume. 

Answer:


Q45. - (Topic 9) 

Which command can you enter to display the hits counter for NAT traffic? 

A. show ip nat statistics 

B. debug ip nat 

C. show ip debug nat 

D. clear ip nat statistics 

Answer:


Latest ccna routing and switching 200-120 pdf:

Q46. - (Topic 3) 

What are three approaches that are used when migrating from an IPv4 addressing scheme to an IPv6 scheme. (Choose three.) 

A. enable dual-stack routing 

B. configure IPv6 directly 

C. configure IPv4 tunnels between IPv6 islands 

D. use proxying and translation to translate IPv6 packets into IPv4 packets 

E. statically map IPv4 addresses to IPv6 addresses 

F. use DHCPv6 to map IPv4 addresses to IPv6 addresses 

Answer: A,C,D 


Q47. - (Topic 4) 

A Cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image. What function does the router perform next? 

A. It checks the configuration register. 

B. It attempts to boot from a TFTP server. 

C. It loads the first image file in flash memory. 

D. It inspects the configuration file in NVRAM for boot instructions. 

Answer:


Q48. DRAG DROP - (Topic 6) 

Answer: 


Q49. - (Topic 5) 

Which three are the components of SNMP? (Choose three) 

A. MIB 

B. SNMP Manager 

C. SysLog Server 

D. SNMP Agent 

E. Set 

Answer: A,B,D 


Q50. - (Topic 2) 

Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN? 

A. ping address 

B. tracert address 

C. traceroute address 

D. arp address 

Answer: