It is impossible to pass Cisco 200-120 exam without any help in the short term. Come to Examcollection soon and find the most advanced, correct and guaranteed Cisco 200-120 practice questions. You will get a surprising result by our Improve CCNA Cisco Certified Network Associate CCNA (803) practice guides.

2021 Nov ccna 200-120 pdf download free:

Q101. - (Topic 4) 

If IP routing is enabled, which two commands set the gateway of last resort to the default gateway? (Choose two.) 

A. ip default-gateway 0.0.0.0 

B. ip route 172.16.2.1 0.0.0.0 0.0.0.0 

C. ip default-network 0.0.0.0 

D. ip default-route 0.0.0.0 0.0.0.0 172.16.2.1 

E. ip route 0.0.0.0 0.0.0.0 172.16.2.1 

Answer: C,E 


Q102. - (Topic 1) 

A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the network administrator is using for this operation? 

A. application 

B. presentation 

C. session 

D. transport 

E. internet 

F. data link 

Answer:


Q103. - (Topic 2) 

Refer to the exhibit. 

Switch-1 needs to send data to a host with a MAC address of 00b0.d056.efa4. What will Switch-1 do with this data? 

A. Switch-1 will drop the data because it does not have an entry for that MAC address. 

B. Switch-1 will flood the data out all of its ports except the port from which the data originated. 

C. Switch-1 will send an ARP request out all its ports except the port from which the data originated. 

D. Switch-1 will forward the data to its default gateway. 

Answer:


Q104. - (Topic 1) 

Which of the following correctly describe steps in the OSI data encapsulation process? (Choose two.) 

A. The transport layer divides a data stream into segments and may add reliability and flow control information. 

B. The data link layer adds physical source and destination addresses and an FCS to the segment. 

C. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information. 

D. Packets are created when the network layer adds Layer 3 addresses and control information to a segment. 

E. The presentation layer translates bits into voltages for transmission across the physical link. 

Answer: A,D 


Q105. - (Topic 4) 

Which type of EIGRP route entry describes a feasible successor? 

A. a backup route, stored in the routing table 

B. a primary route, stored in the routing table 

C. a backup route, stored in the topology table 

D. a primary route, stored in the topology table 

Answer:


Leading ccna 200-120 pdf study guide:

Q106. - (Topic 4) 

Which two are advantages of static routing when compared to dynamic routing? (Choose two.) 

A. Configuration complexity decreases as network size increases. 

B. Security increases because only the network administrator may change the routing table. 

C. Route summarization is computed automatically by the router. 

D. Routing tables adapt automatically to topology changes. 

E. An efficient algorithm is used to build routing tables, using automatic updates. 

F. Routing updates are automatically sent to neighbors. 

G. Routing traffic load is reduced when used in stub network links. 

Answer: B,G 


Q107. - (Topic 6) 

Refer to the exhibit. 

Statements A, B, C, and D of ACL 10 have been entered in the shown order and applied to interface E0 inbound, to prevent all hosts (except those whose addresses are the first and last IP of subnet 172.21.1.128/28) from accessing the network. But as is, the ACL does not restrict anyone from the network. How can the ACL statements be re-arranged so that the system works as intended? 

A. ACDB 

B. BADC 

C. DBAC 

D. CDBA 

Answer:


Q108. - (Topic 4) 

Which command shows your active Telnet connections? 

A. show cdp neigbors 

B. show session 

C. show users 

D. show vty logins 

Answer:


Q109. - (Topic 5) 

When a DHCP server is configured, which two IP addresses should never be assignable to hosts? (Choose two.) 

A. network or subnetwork IP address 

B. broadcast address on the network 

C. IP address leased to the LAN 

D. IP address used by the interfaces 

E. manually assigned address to the clients 

F. designated IP address to the DHCP server 

Answer: A,B 


Q110. - (Topic 2) 

Assuming the default switch configuration, which VLAN range can be added, modified, and removed on a Cisco switch? 

A. 1 through 1001 

B. 2 through 1001 

C. 1 through 1002 

D. 2 through 1005 

Answer: