In fact, Examcollection provides you with an amazing opportunity to make your career lifestyle better. We aim to give attention to the superior high quality of our Cisco Cisco 200-310 exam dumps. Demands for the Cisco certification exam demos get increased since we supply with the high-quality and most up-to-date products regarding all the candidates. Providing you work tirelessly on the Cisco 200-310 demos, an individual can?¡¥t miss your 200-310 certificate in the initial attempt.

2021 Dec 310-200 latest dumps:

Q151. When there is a need for immunity to EMI for connecting locations that are greater than 100 meters apart, which two solutions can be utilized? (Choose two.) 

A. multimode fiber 

B. Fiber Channel 

C. HVDC transmission lines 

D. single-mode fiber 

E. serial RS-232 

F. Gigabit Ethernet 1000BASE-CX 

Answer: A,D 


Q152. When evaluating network designs, what indicator demonstrates that the modular approach was followed? 

A. ability to scale 

B. follows best practices 

C. redundant connectivity 

D. easy to deploy 

Answer:


Q153. Which three options represents the components of the Teleworker Solution? (Choose three.) 

A. Cisco Unified IP Phone 

B. Cisco 880 Series Router 

C. Aironet Office Extend Access Point 

D. Catalyst 3560 Series Switch 

E. Cisco 2900 Series Router 

F. MPLS Layer 3 VPN 

G. Leased lines 

Answer: A,B,E 


Q154. You are designing a network that requires a routing protocol that will use minimal network bandwidth. Which would satisfy this requirement? 

A. RIPv2 

B. RIPng 

C. OSPF 

D. ARP 

E. EGP 

Answer:


Q155. An organization is deciding what routing protocol to use throughout their network. What must be considered if routing is to be performed at the access layer? 

A. reduced scalability of the network when introducing a large number of switch blocks into the routing table 

B. centralized management of access control lists at the distribution layer 

C. reliability when implementing routing over spanning-tree at the access layer 

D. performance differences between core, distribution and access layer equipment 

Answer:


Most up-to-date casio 電子ピアノ privia px-110/px-200/px-310/px-500l用折りたたみ式スタンド cs-53p:

Q156. DRAG DROP 

Answer: 


Q157. What two CoS values are used by voice traffic? (Choose two.) 

A. COS1 

B. COS2 

C. COS3 

D. COS4 

E. COS5 

Answer: C,E 


Q158. DRAG DROP 

Answer: 


Q159. When designing a WAN backup for voice and video applications, what three types of connections should be used? (Choose three.) 

A. Private WAN 

B. internet 

C. ISDN 

D. MPLS 

E. dial-up 

F. ATM 

G. DSL 

Answer: A,C,D 


Q160. Characterizing an existing network requires gathering as much information about the network as possible. Which of these choices describes the preferred order for the information-gathering process? 

A. site and network audits, traffic analysis, existing documentation and organizational input 

B. existing documentation and organizational input, site and network audits, traffic analysis 

C. traffic analysis, existing documentation and organizational input, site and network audits 

D. site and network audits, existing documentation and organizational input, traffic analysis 

Answer:

Explanation: 

This section describes the steps necessary to characterize the existing network infrastructure and all sites. This process requires three steps: 

Step 1. Gather existing documentation about the network, and query the organization to discover additional information. Organization input, a network audit, and traffic analysis provide the key information you need. (Note that existing documentation may be inaccurate.) 

Step 2. Perform a network audit that adds detail to the description of the network. If possible, use traffic-analysis information to augment organizational input when you are describing the applications and protocols used in the network. 

Step 3. Based on your network characterization, write a summary report that describes the health of the network. With this information, you can propose hardware and software upgrades to support the network requirements and the organizational requirements.