Ucertify 200-355 test questions are prepared by just Skillfully developed in addition to Professionals delivering the top option to achievements together with easiest messages in keeping with 200-355 Official certifications Test Desired goals. You can expect Three months with zero cost messages with regard to 200-355 Test. The 200-355 . torrent has the ability to ensure you get certified within little time. After you start using our own 200-355 rapidshare in addition to 200-355, you can find out a real difference. Within a few hours, it is possible to secure your own 200-355 Official certifications Test with confidence in addition to great lots.

2021 Apr 200-355 braindumps

Q101. When a wireless guest network is implemented using auto-anchor mobility in a controller-based wireless network, which controller is responsible for a guest client's IP address and their security configuration? 

A. any controller that supports the same VLAN 

B. foreign controller 

C. anchor controller 

D. master controller 

E. RF group master controller 

Answer:


Q102. Which two factors must be considered when evaluating an RF interferer for severity? (Choose two.) 

A. distance from the AP 

B. dBm 

C. the type of security crack being used 

D. duty cycle 

E. number of interfering IP stations in the cell 

F. duplicate SSID 

Answer: B,D 


Q103. When using multiple SSIDs on a lightweight AP, how does the traffic of each SSID reach the 802.3 network? 

A. provide routing between them at the core so that the SSIDs can reach the internet 

B. configure 802.11q trunking on the Ethernet switch port that is connected to the AP 

C. configure ACLs at the switch port that will allow all desired SSIDs to pass traffic 

D. configure the SSIDs on the WLC and it will regulate the traffic based on traffic type 

Answer:


Q104. Refer to the exhibit. A customer is using central web authentication with a Cisco 5508 Wireless Controller and Cisco Identity Services Engine. An error occurs when wireless clients are redirected to the hosted splash page. What is causing the client error? 

A. Secure Web Mode is disabled on the WLC. 

B. OCSP is disabled on the WLC. 

C. Management Via Dynamic Interface is disabled on the WLC. 

D. Ethernet Multicast Forwarding is enabled on the WLC. 

Answer:


Q105. Which method of encryption does the 802.11i standard use? 

A. AES/CCMP 

B. AES/ECB 

C. AES/OCB 

D. TKIP 

E. both AES/ECB and AES/CCMP 

Answer:


Most up-to-date 200-355 practice exam:

Q106. An installation uses a 21dBi parabolic dish. It is connected to the 802.11n radio via low loss antenna coax rated at 4dB loss/100 feet. After testing, it has been determined that 2mW of power will be lost in the cable. An EIRP producing 200mW is desired. What should the transmit power be set to? 

A. 8mW 

B. 3dBm 

C. 3.16mW 

D. 5mW 

Answer:


Q107. What tab contains access point configuration in the WCS? 

A. Controller > Access Points 

B. Configure > Access Points 

C. General > Configure > Access Points 

D. System > Configure > Access Points 

Answer:


Q108. Refer to the exhibit. 

A customer has enabled the primary DNS server to return the correct controller IP address in response to a CISCO-CAPWAP-CONTROLLER.localdomain request coming from new access points associating to the wireless network. The access points seem to still be receiving the wrong IP address and cannot associate to the primary controller. 

Why are the access points receiving the wrong IP information? 

A. The DHCP option 43 has an incorrect controller IP address configured. 

B. The DNS server must be configured to respond to CISCO-LWAPP-CONTROLLER.localdomain request. 

C. The controller and wireless action point need to be Layer 2 adjacent. 

D. The controller must be configured for DHCP option 15 request. 

Answer:


Q109. An AP using version 7.0 MR1 broadcasts a Layer 3 CAPWAP discovery message on the local IP subnet. Which step does the AP take next? 

A. Determine if the controller responses include the primary controller. 

B. Determine if the controller responses include the master controller. 

C. Send a discovery request using DHCP option 43. 

D. Send a discovery request using DNS. 

E. Send a discovery request using locally stored information on the AP. 

F. Send a discovery request using OTAP. 

Answer:


Q110. Which module does the Cisco AnyConnect Secure Mobility client integrate into the AnyConnect client package for access to both wired and wireless networks? 

A. Network Access Manager 

B. Telemetry 

C. Web Security 

D. DART 

Answer: