we provide Virtual Cisco 300 075 vce test engine which are the best for clearing 300 075 vce test, and to get certified by Cisco Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2). The 300 075 ciptv2 Questions & Answers covers all the knowledge points of the real 300 075 ciptv2 exam. Crack your Cisco 300 075 dump Exam with latest dumps, guaranteed!

Q21. Refer to the exhibit. 

Assume that the HQ phones have access to the HQ partition, and BR phones have access to the BR partition. Which set of implementations would best address the overlapping directory number extensions for intersite (WAN) calling between the HQ site and the BR site? 

A. Configure a route pattern 8222.[12]XXX for site HQ, and assign it to partition HQ. Configure the called party DDI of Predot.Configure a route pattern for site BR 8111.[1-3]XXX, and assign it to partition BR. Configure called party DDI Predot.Use the local gateway at each site. Prefix the appropriate site code for the calling number. 

B. Configure a single route pattern for both sites 8[12,12,12].[1-32]XXX. Use a route list that contains the local route group for each site. Prefix the appropriate site code for the calling number. 

C. Configure a translation pattern 8222.[12]XXX for site HQ, and assign it to partition HQ. Use a CSS that contains the partitions for BR phones.Configure a translation pattern 8111.[1-3]XXX for site BR, and assign it to partition BR. Use a CSS that contains the partitions for HQ phones.For both translation patterns, configure the called party DDI of Predot. Prefix the appropriate site code for the calling number. 

D. Configure a translation pattern 8222.[12]XXX for site HQ, and assign it to partition BR. Use a CSS that contains the partitions for HQ phones.Configure a translation pattern 8111.[1-3]XXX for site BR, and assign it to partition HQ. Use a CSS that contains the partitions for BR phones.For both translation patterns, configure the called party DDI of Predot. Prefix the appropriate site code for the calling number. 

Answer:


Q22. Video calls using 384 kbps need to be supported across a gatekeeper-controlled trunk. What value should be entered into the gatekeeper to support this bandwidth? 

A. 768 kbps 

B. 384 kbps 

C. 512 kbps 

D. 192 kbps 

Answer:

Explanation: 

Incorrect Answer: A, C, D A 384-kb/s video call may comprise G.711 at 64 kb/s (for audio) plus 320 kb/s (for video). This sum does not include overhead. If the audio codec for a video call is G.729 (at 24 kb/s), the video rate increases to maintain a total bandwidth of 384 kb/s. Link: 

http://www.ciscosystems.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a08video.html#wp1059726 


Q23. Which remote-site redundancy technology fails over to POTS dial peers from the Cisco Unified Communications Manager dial plan during a WAN failure? 

A. MGCP fallback 

B. H.323 fallback 

C. SCCP fallback 

D. SIP fallback 

Answer:


Q24. In what Cisco solution is Simple Network-Enabled Auto Provision technology used? 

A. Cisco Unified Gateway Duplication 

B. Cisco Unified CallManager Redundancy 

C. Cisco Unified SRST 

D. Cisco Unified Call Survivability 

Answer:

Explanation: 

Incorrect Answer: A, B, D When the system automatically detects a failure, Cisco Unified SRST uses Simple Network Auto Provisioning (SNAP) technology to auto-configure a branch office router to provide call processing for the Cisco Unified IP phones that are registered with the router Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmesr st.html 


Q25. Which ability does the Survivable Remote Site Telephony feature provide? 

A. a means to allow the local site to continue to send and receive calls in the event of a WAN failure 

B. a means to route calls on-net through other sites during high utilization periods 

C. a method that allows for backup calls in the event that your gateway fails 

D. the ability to force a call out of a certain trunk when the Cisco Unified Communications Manager is being upgraded 

Answer:


Q26. Scenario There are two call control systems in this item. The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 7965 and 9971 Video IP Phones. The Cisco VCS and TMS control the Cisco TelePresence Conductor, the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows. 

Use the exhibits to answer the following questions. 

DNS Servers 

Device Pool 

Expressway 

ILS 

Locations 

MRA 

Speed Dial 

SIP Trunk 

The intercluster URI call routing no longer allows calls between sites. What is the reason why this would happen? (Choose two) 

A. Wrong SIP domain configured. 

B. User is not associated with the device. 

C. IP or DNS name resolution issue. 

D. No SIP route patterns for cisco.lab exist. 

Answer: C,D 


Q27. The corporate WAN has been extended to two newly acquired sites and it includes gatekeeper support. Each site has a Cisco CallManager and an H.323 gateway that allows connection to the PSTN. Which connection method is best for these two new customers? 

A. H.225 trunk (gatekeeper-controlled) 

B. intercluster trunk (non-gatekeeper controlled) 

C. SIP trunk 

D. intercluster trunk (gatekeeper-controlled) 

Answer:


Q28. On which two call legs is the media encryption enforced in a Collaboration Edge design? (Choose two.) 

A. Expressway-C to Cisco Unified Communications Manager 

B. Expressway-C to Expressway-E 

C. Expressway-E to outside-located endpoint 

D. Expressway-E to Cisco Unified Communications Manager 

E. Expressway-C to internal endpoint 

Answer: B,C 


Q29. How is a SIP trunk in Cisco Unified Communications Manager configured for SIP precondition? 

A. The configuration is done by selecting a SIP precondition trunk for trunk type. 

B. The configuration is automatically selected when RSVP is enabled for the location assigned to the trunk. 

C. SIP precondition is configured by selecting E2E for RSVP over SIP on the default SIP profile assigned to the SIP trunk. 

D. SIP precondition is configured by configuring a new SIP profile and selecting E2E for RSVP over SIP. The new SIP profile must then be assigned to the SIP trunk. 

Answer:


Q30. In a distributed call processing network with locations-based CAC, calls are routed to and from intercluster trunks. Which trunk type is implemented in this network? 

A. intercluster trunk with gatekeeper control 

B. intercluster trunk without gatekeeper control 

C. SIP trunk 

D. h225 trunk 

Answer: