It is more faster and easier to pass the Cisco 300 075 vce exam by using High quality Cisco Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) questuins and answers. Immediate access to the Replace cisco 300 075 Exam and find the same core area 300 075 pdf questions with professionally verified answers, then PASS your exam with a high score now.
Q51. Refer to the exhibit:
The exhibit shows a SAF Forwarder configuration attached to a Cisco Unified Communications Manager.
Which minimum configuration for a Cisco Unified Communications Manager Express SAF Forwarder is needed to establish a SAF neighbor relationship with this SAF Forwarder?
A. router eigrp SAFiservice-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-familyvoice service safprofile trunkroute 1session protocol sip interface Loopback1 transport tcp port 5060!
B. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit- service-family!voice service safprofile trunk-route 1session protocol sip interface Loopback1 transport tcp port 5060!profile dn-block 1 alias-prefix 1972555pattern 1 type extension 4xxx!profile callcontrol 1dn-servicetrunk-route 1dn-block 1dn-block 2!channel 1 vrouter SAF asystem 1subscribe callcontrol wildcardedpublish callcontrol 1!
C. router eigrp SAF!service-family ipv4 autonomous-system 1!topology baseexit-sf-topologyexit-service-family!
D. None of above configurations contain sufficient information.
Incorrect Answer: A, B, D only following configuration is enough router eigrp SAF service-family ipv4 autonomous-system 1 exit-service-family link:
Q52. Which trunk should you use in an H.323 gatekeeper-controlled network?
E. MGCP FXO trunk
F. MGCP T1/E1 trunk
Q53. Which symbol is required for globalized call routing?
Q54. Which statement is true when device mobility mode is enabled or disabled in the Phone
A. The device mobility mode phone settings take precedence over the service parameter settings.
B. The service parameter settings take precedence over the device mobility mode phone settings.
C. The combined service parameter settings and the device mobility mode phone settings will be used.
D. The default settings will be used due to the conflicts.
Q55. In a node-specific Service Advertisement Framework forwarder deployment model, what is the maximum number of Service Advertisement Framework forwarders that you can assign to a specific node?
Q56. Which configuration command disables the secondary dial tone on the branch office ISR for users calling from the PSTN into the branch office during a WAN failure?
B. voice translation-rule
C. incoming called-number
Q57. Which two options must be selected in the SIP Trunk Security Profile configuration between Cisco Unified Communications Manager and Expressway? (Choose two)
A. Enable application-level authorization
B. Accept presence subscription
C. Accept out-of-dialog refer
D. Accept unsolicited notification
E. Accept replaces header
F. Transmit security status
G. Allow charging header
Q58. Which option describes a function of SIP preconditions?
A. SIP preconditions enable end-to-end RSVP over an SIP trunk.
B. SIP preconditions enable RSVP between Cisco IP Phones.
C. SIP preconditions can be enabled in a gatekeeper.
D. SIP preconditions enable end-to-end RSVP for calls through the PSTN.
Q59. Refer to the exhibit.
The exhibit shows centralized Cisco Unified Communications Manager configuration components for TEHO calls to U.S. area code 408 from the U.K. The PSTN access code for the U.K. is 9 and 001 for international calls to the U.S. What should the TEHO-US route list configuration consist of?
A. First route group should point only to the U.K. gateway. The second route group should point to the U.S. gateway.
B. First route group should be only the local route group. The second route group should point to the U.S. gateway.
C. First route group should point only to the U.S. gateway. The second route group should be the local route group.
D. The TEHO-US route list should contain only the local route group. The globalized configuration means that the appropriate gateway will be selected automatically.
E. The +! route pattern should point directly to the U.S. gateway.
Incorrect Answer: A, B, D The route group points to one or more gateways and can choose the gateways for call routing based on preference. The route group can serve as a trunk group by directing all calls to the primary device and then using the secondary devices when the primary is unavailable. One or more route lists can point to the same route group. Link:
Q60. Refer to the exhibit.
IT shows an H.323 gateway configuration in a Cisco Unified Communications Manager environment. An inbound PSTN call to this H.323 gateway fails to connect to IP phone extension 2001. The PSTN user hears a reorder tone. Debug isdn q931 on the H.323 gateway shows the correct called-party number as 5015552001. Which two configuration changes can correct this issue? (Choose two.)
A. Add port 1/0:23 to dial-peer voice 123 pots.
B. Ensure that the Significant Digits for inbound calls on the H.323 gateway configuration is 4.
C. Add a voice translation profile to truncate the number from 10 digits to 4 digits. Apply the voice translation profile to the Voice-port. The configuration field "Significant Digits for inbound calls" is left at default (All).
D. Add the command h323-gateway voip id on interface vlan120.
E. Change the destination-pattern on the dial-peer voice 23000 VoIP to 501501? and change the Significant Digits for inbound calls to 4.
Incorrect Answer: A, C, D Choose the number of significant digits to collect, from 0 to 32. Cisco Unified Communications Manager counts significant digits from the right (last digit) of the number that is called. Link: http://cisco.biz/en/US/docs/voice_ip_comm/cucmbe/admin/8_6_1/ccmcfg/b06trunk.html