Cisco qualification may be the worlds many respected international qualification. Therefore 300-075 is quite required for those who find themselves anxious to penetrate the IT company. But its very difficult for those who are active functioning or even studying to pass the Implementing Cisco IP Telephony and Video, Part 2 (CIPTV2) check. Ucertify Cisco 300-075 research manuals will help you saving a large amount of time,vitality as well as source inside the 300-075 check. Youll be able to handle this particular 300-075 check successfully through our own 300-075 pdf file as well as check engine. Were able to keep the item promptly and invite individuals to understand Cisco knowledge very easily. You can also down load the Cisco 300-075 pdf file trial edition totally free.

2021 Jun 300-075 test question

Q161. When you use the Query wizard to configure the trace and log central feature to collect install logs, if you have servers in a cluster in a different time zone, which time is used? 

A. TLC adjusts the time change appropriately. 

B. TLC uses its local time for all systems. 

C. TLC queries for the time zone as part of configuration. 

D. TLC produces an error and must be run remotely. 

Answer: A 


Q162. Which bandwidth amounts are correct for configuring locations? 

A. 8 kb/s for G.729, 64 kb/s for G.711, and 64 kb/s for G.722 

B. 8 kb/s for G.729, 64 kb/s for G.711, and 16 kb/s for G.722 

C. 64 kb/s for G.729, 64 kb/s for G.711, and 64 kb/s for G.722 

D. 8 kb/s for G.729, 8 kb/s for G.711, and 8 kb/s for G.722 

Answer: A 


Q163. Which three options are supplementary services that are affected by MTP? (Choose three.) 

A. Call Hold 

B. Call Transfer 

C. Call Park 

D. Call Pickup 

E. Speed Dial 

F. Call Back 

Answer: A,B,C 


300-075  exam answers

Refresh 300-075 exam:

Q164. Which remote-site redundancy technology fails over to POTS dial peers from the Cisco Unified Communications Manager dial plan during a WAN failure? 

A. MGCP fallback 

B. H.323 fallback 

C. SCCP fallback 

D. SIP fallback 

Answer: A 


Q165. Which two features require or may require configuring a SIP trunk? (Choose two.) 

A. SIP gateway 

B. Call Control Discovery between a Cisco Unified Communications Manager and Cisco Unified Communications Manager Express 

C. Cisco Device Mobility 

D. Cisco Unified Mobility 

E. registering a SIP phone 

Answer: A,B 

Explanation: 

Incorrect Answer: C, D, E All protocols require that either a signaling interface (trunk) or a gateway be created to accept and originate calls. Device mobility allows Cisco Unified Communications Manager to determine whether the phone is at its home location or at a roaming location. Cisco Unified Mobility gives users the ability to redirect incoming IP calls from Cisco Unified Communications Manager to different designated phones, such as cellular phones. Link: 

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a08sip.html# wpxref77849 


Q166. Which three options are overlapping parameters for roaming when a device is configured for Device Mobility? (Choose three.) 

A. MRGL 

B. location 

C. network locale 

D. codec 

E. extension 

F. device pool 

Answer: A,B,C 


Q167. Refer to the exhibit. 


Assume that the HQ phones have access to the HQ partition, and BR phones have access to the BR partition. Which set of implementations would best address the overlapping directory number extensions for intersite (WAN) calling between the HQ site and the BR site? 

A. Configure a route pattern 8222.[12]XXX for site HQ, and assign it to partition HQ. Configure the called party DDI of Predot.Configure a route pattern for site BR 8111.[1-3]XXX, and assign it to partition BR. Configure called party DDI Predot.Use the local gateway at each site. Prefix the appropriate site code for the calling number. 

B. Configure a single route pattern for both sites 8[12,12,12].[1-32]XXX. Use a route list that contains the local route group for each site. Prefix the appropriate site code for the calling number. 

C. Configure a translation pattern 8222.[12]XXX for site HQ, and assign it to partition HQ. Use a CSS that contains the partitions for BR phones.Configure a translation pattern 8111.[1-3]XXX for site BR, and assign it to partition BR. Use a CSS that contains the partitions for HQ phones.For both translation patterns, configure the called party DDI of Predot. Prefix the appropriate site code for the calling number. 

D. Configure a translation pattern 8222.[12]XXX for site HQ, and assign it to partition BR. Use a CSS that contains the partitions for HQ phones.Configure a translation pattern 8111.[1-3]XXX for site BR, and assign it to partition HQ. Use a CSS that contains the partitions for BR phones.For both translation patterns, configure the called party DDI of Predot. Prefix the appropriate site code for the calling number. 

Answer: C