Testking offers free demo for aerospatiale alenia atr 42 300 320 exam. "Designing Cisco Network Service Architectures", also known as ccdp arch 300 320 pdf exam, is a Cisco Certification. This set of posts, Passing the Cisco 300 320 arch exam, will help you answer those questions. The 300 320 arch Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco cisco 300 320 dumps exams and revised by experts!

Q11. Which two of these correctly describe asymmetric routing and firewalls? (Choose two.) 

A. only operational in routed mode 

B. only operational in transparent mode 

C. only eight interfaces can belong to an asymmetric routing group 

D. operational in both failover and non-failover configurations 

E. only operational when the firewall has been configured for failover 

Answer: C,D 


Q12. Which option is a benefit of site-to-site VPNs? 

A. less configuration required than a WAN circuit 

B. more secure than a dedicated WAN circuit 

C. less expensive than a dedicated WAN circuit 

D. more reliable than a dedicated WAN circuit 

Answer:


Q13. A e-commerce network has many devices that often need to be upgraded on a regular basis. What technology will ensure IP packets continue to be forwarded even during a device failover? 

A. stateful switchover 

B. nonstop forwarding 

C. route processor redundancy 

D. optimized edge routing 

E. enhanced object tracking 

Answer:


Q14. Distinct, physical redundancy within a network layer is a key characteristic that contributes to the high availability of the hierarchical network design. Which of the following is not an examples of this model? 

A. SAN extension with dual fabrics such as a yellow VSAN and a blue VSAN utilized via multipath software 

B. Redundant power supplies and hot-swappable fan trays in Aggregate switches 

C. A single SAN fabric with redundant uplinks and switches 

D. Servers using network adapter teaming software connected to dual-attached access switches 

Answer:


Q15. Refer to the exhibit. Which option should be the default gateway for the PC1 that is shown? 

A. 10.3.2.4 

B. 10.2.2.2 

C. 10.2.2.1 

D. 10.2.2.3 

Answer:


Q16. Which statement is the most accurate regarding IPsec VPN design for an Enterprise Campus environment? 

A. VPN device IP addressing must align with the existing Campus addressing scheme. 

B. The choice of a hub-and-spoke or meshed topology ultimately depends on the number of remotes. 

C. Sizing and selection of the IPsec VPN headend devices is most affected by the throughput bandwidth requirements for the remote offices and home worker 

D. Scaling considerations such as headend configuration, routing protocol choice, and topology have the broadest impact on the design. 

Answer:


Q17. When is a first-hop redundancy protocol needed in the distribution layer? 

A. when the design implements Layer 2 between the access and distribution blocks 

B. when multiple vendor devices need to be supported 

C. when preempt tuning of the default gateway is needed 

D. when a robust method of backing up the default gateway is needed 

E. when the design implements Layer 2 between the access switch and the distribution blocks 

Answer:


Q18. What is one reason to implement Control Plane Policing? 

A. allow OSPF routing protocol to advertise routes 

B. protect the network device route processor from getting overloaded by rate limiting the incoming control plane packets 

C. allow network devices to generate and receive packets 

D. protect the data plane packets 

Answer:


Q19. Which option describes the purpose of the auto-cost reference bandwidth 10000 command under the OSPF process? 

A. Recognize redundant 10 Megabit links. 

B. Differentiate cost on a 10 Gigabit Ethernet trunk link. 

C. Change the default bandwidth for a 100 Megabit link. 

D. Adjust the link bandwidth for routing protocols. 

Answer:


Q20. Which technology is an example of the need for a designer to clearly define features and desired performance when designing advanced WAN services with a service provider? 

A. FHRP to remote branches 

B. Layer 3 MPLS VPNs secure routing 

C. Control protocols (for example Spanning Tree Protocol) for a Layer 3 MPLS service 

D. Intrusion prevention, QoS, and stateful firewall support network wide 

Answer: