Want to know Pass4sure 300-360 Exam practice test features? Want to lear more about Cisco Designing Cisco Wireless Enterprise Networks certification experience? Study Exact Cisco 300-360 answers to Replace 300-360 questions at Pass4sure. Gat a success with an absolute guarantee to pass Cisco 300-360 (Designing Cisco Wireless Enterprise Networks) test on your first attempt.

2021 Jan 300-360 dumps

Q31. A customer has deployed an N+N redundant wireless infrastructure. In this deployment, the access points have been salt and peppered between controllers. What configuration would be necessary to cut down on the use of mobility tunnels for voice clients?

A. mobility anchor

B. KIS based CAC

C. media session snooping

D. re-anchor roamed voice clients

Answer: D


Q32. A hospital environment was designed to guarantee RF coverage at or better than -67 dBm in the 5 GHz spectrum. The customer mandates that RRM be used for DCA and TPC in both bands. After deployment, why do many of the legacy 802.11b/g devices have difficulty maintaining connectivity?

A. Excessive co-channel interference in the 2.4 GHz band exists.

B. Excessive overlapping channels in the 2.4 GHz band exists.

C. TPC drastically reduces Tx power in the 2.4 GHz band.

D. TCP drastically increases Tx power in the 2.4 GHz band.

Answer: C


Q33. An engineer is performing a predictive wireless design for a medical treatment environment, which requires data and voice services. Which of the following is a requirement for the design?

A. overlapping -72 dBm coverage from two access points

B. overlapping -67 dBm coverage from two access points

C. continuous -67 dBm coverage from one access point

D. continuous -72 dBm coverage from one access point

Answer: C


Refresh 300-360 test preparation:

Q34. Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)

A. Use the Cisco wireless phone site survey client utility.

B. Use a separate Cisco Wireless Lan Controller.

C. Enable load balance on voice WLANs.

D. Maintain -67dBM as a minimal RSSI.

E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.

F. Enable lower data rates for 2.4-GHz data WLAN.

Answer: A,D,E


Q35. An engineer is tuning RRM parameters to improve client connectivity. Which channel band results in the best 802.11n client compatibility?

A. UNII-2

B. UNII-2e

C. UNII-3

D. UNII

E. UNII-1

Answer: E

Explanation:

802.11n operates on the same channel as 802.11a. For better compatibility with 802.11n clients, it is recommended to stay on lower channels (UNII-1 band).

Reference: http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/108184config-802-11n-wlc.html


Q36. An engineer is installing a wireless network in an industrial area with extreme temperatures and a significant amount of dust. Which enclosure should be used to protect the APs?

A. ACU

B. ADU

C. NEMA

D. WLSE

Answer: C

Explanation:

Sometimes access points (APs) are located in areas where they are subject to extreme moisture, temperatures, dust and particles. These APs might need to be mounted inside a sealed enclosure. The NEMA has a rating system for these enclosures, which are generally called NEMA enclosures.

Reference: http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/68666-wireless-sitesurvey-faq.html