The particular Exambible Cisco examine manuals are already actively playing a far more plus more part inside candidates researching lifestyle, it help save a lot of time for people avoid to go to this course. Our own Cisco 350-080 dumps also include many simulators workout routines questions. The particular simulators workout routines questions tend to be blended in to the CCIE Data Center Written Exam solutions in our Cisco 350-080 manuals. We promise an individual that you receive the achievement deffinately providing you strive with this 350-080 certification examine supplies. The more an individual undertake the Exambible 350-080 dumps, the higher indicate you are able to achieve. You can consider Cisco 350-080 guides or even the electronic books everywhere and also when you want inside the reason of they are all portable. Exambible will ensure the maximize advantages of consumers as a result of the high-quality products.

2021 Jul examcollection 350-080:

Q201. Refer to the exhibit.


Server 1 and server 2 are on the same VLAN but cannot reach each other. Which option describes the reason?

A. Interface VALN (SVI) must be configured for this VLAN.

B. VLAN is not allowed on the peer link.

C. VLAN is not on FabricPath mode.

D. Type2 inconsistency prevents the communication.

Answer: C


Q202. RAG DROP

Drag and drop the correct description on the left onto the protocols and features on the right. Not all options will be used.


Answer: 



Q203. Refer to the exhibit.


The interface remains in a down state after entering the command that is shown in the exhibit. What is the cause of the problem?

A. The feature interface-vlan command must be configured.

B. The VDC contains only F1 interfaces.

C. There are IP address conflicts.

D. The VDC is “type OTV.”

E. The command copy run start was not entered.

Answer: B


Q204. Which Cisco Nexus 1000v switch CLI command is used to verify the connection between the Cisco Nexus 1000v Series switch and Vmware?

A. show module

B. show svd console

C. show svs connections

D. show svs domain

E. show svd domain

Answer: C


Q205. Refer to the exhibit.


The servers in this network are connected to an A-B SAN design. What is required for hosts to support a high-availability Fibre Channel connection to a storage controller?

A. Multipath drivers should be installed on all the servers.

B. Multipath drivers should be installed on the CNA of S1 and S3.

C. High availability for Fibre Channel is controlled by the storage controller, and there is no need to

add or make changes on the server side.

D. S1 and S3 require that multipath drivers are installed, but S2 does not.

E. Multipath drivers should be installed on all CNAs of all servers.

Answer: A


350-080  braindumps

Renew 350-080 test:

Q206. Virtual PortChannels (vPCs) allow links that are physically connected to two different Cisco switches to appear to a third downstream device as coming from a single device and as part of a single port channel. Which of the following are components of a Virtual PortChannel system? (Choose four)

A. Two peer devices: the vPC peers of which one is primary and one is secondary and are part of a vPC domain.

B. A Layer 3 Gigabit Ethernet link called peer-keepalive link to resolve dual-active scenarios

C. A redundant 10 Gigabit Ethernet PortChannel called a peer link to carry traffic from one system to the other when needed

D. vPC member ports forming the PortChannel

E. A dot1q trunk between the vPC peers

F. A management port that can be used as peer-keepalive link to resolve dual-active scenarios.

Answer: A,B,C,D


Q207. Which three statements about OTV are true? (Choose three.)

A. An internal interface is a Layer 2 interface on the edge device that connects to the VLANs that are to be extended. These VLANs typically form a Layer 2 domain known as a site and can contain site-based switches or site-based routers. The internal interface is a Layer 2 access or trunk interface regardless of whether the internal interface connects to a switch or a router.

B. An external interface is a Layer 2 interface on the edge device that connects to the VLANs that are to be extended. These VLANs typically form a Layer 2 domain known as a site and can contain site-based switches or site-based routers. The external interface is a Layer 2 access or trunk interface regardless of whether the external interface connects to a switch or a router.

C. An overlay interface is a logical multiaccess multicast-capable interface. The overlay interface encapsulates Layer 2 frames in IP unicast or multicast headers.

D. An overlay interface is a logical multiaccess multicast-capable interface. The overlay interface encapsulates Layer 3 frames in IP unicast or multicast headers.

E. The join interface is one of the uplink interfaces of the edge device. The join interface is a point-to-point routed interface. The edge device joins an overlay network through this interface. The IP address of this interface is used to advertise reachability of a MAC address that is present in this site.

F. The join interface is one of the uplink interfaces of the edge device. The join interface is a point-to-point routed interface. The edge device joins an overlay VLAN through this interface. The IP address of this interface is used to advertise reachability of a MAC address that is present in this VLAN.

Answer: A,C,E


Q208. On a Cisco Nexus 7000 Series Switch, what is the purpose of this command?

Switch# config terminal

switch(config)# mac address-table learning-mode conversational vlan 1-10

switch(config)#

A. Enable conversational learning on FabricPath vlans 1-10 for F-Series module

B. Enable FabricPath protocol on VLANs 1–10

C. No need for this command as conversational learning is enabled by default for all VLANs.

D. Enable conversational learning on Classical Ethernet VLAN for F-Series module

Answer: A


Q209. Which four statements about NetFlow configuration on the Cisco Nexus 7000 Series switch are true? (Choose four.)

A. You must configure a source interface. If you do not configure a source interface, the exporter will remain in a disabled state.

B. You must configure a valid record name for every flow monitor.

C. If you add a member to a port channel that is already configured for Layer 2 NetFlow, its NetFlow configuration is removed and the Layer 2 configuration of the port channel is added to it.

D. If you change a Layer 2 interface to a Layer 3 interface, NetFlow configuration on the interface will automatically switch to Layer 3 mode.

E. Use v9 export to see the full 32-bit SNMP ifIndex values at the NetFlow connector.

F. NetFlow is a licensed feature and is available only in the LAN_ENTERPRISE_SERVICES_PKG license.

Answer: A,B,C,E


Q210. Which two statements about OTV are true? (Choose two.)

A. Only one join interface can be specified per overlay.

B. OTV runs over a distance vector routing protocol.

C. The join interface must be a Layer 2 interface.

D. No special license is required for OTV.

E. OTV requires a separate VDC if SVIs for the extended VLANs are to be configured on the same switch.

F. The authoritative edge device is the active forwards for multicast and unknown unicast for all VLANs.

Answer: A,E