Our skilled specialists compile the particular Cisco certification practice dumps based on the syllabus associated with Cisco Cisco real exam which usually you will find all the key points and targets. The Cisco 352-001 exam questions and answers are updated regularly in accordance with the Cisco certification true exam. You will find the particular Cisco practice demos quite useful, precise and accurate.

2021 Dec actual test 352-001:

Q61. When designing a large full mesh network running OSPF, how would you reduce LSA repetition? 

A. Elect a DR and BDR. 

B. Use access control lists to control outbound advertisements. 

C. Choose one or two routers to re-flood LSA information. 

D. Put each of the point-to-point links in your full mesh networking into a separate area. 

Answer:


Q62. You have been tasked to create a Layer 2 network design that uses vPC to provide resiliency and avoid loops. vPC removes Layer 2 loops while providing redundancy through which mechanism? 

A. dual-active detection 

B. address synchronization 

C. strict forwarding rules 

D. Bridge Assurance 

Answer:


Q63. A company wants to use an external appliance between its data center and WAN to optimize email and HTTP communications. The traffic flow must pass this appliance in both directions. The appliance is connected with only one interface to a Cisco IOS router and has a single IP address. Which two adjustments can you make to the network design so that the appliance is added into the traffic path? (Choose two.) 

A. Configure static routes to route the traffic to the appliance. 

B. Adjust the dynamic routing to route the traffic to the appliance. 

C. Configure NAT to force the traffic to the appliance. 

D. Configure a route map at the data center-side interface to forward the traffic to the appliance IP address. 

E. Configure a route map at the appliance-facing interface to forward the traffic to the appliance IP address. 

F. Configure a route map at the WAN-side interface to forward the traffic to the appliance IP address. 

Answer: DF 


Q64. Currently a service provider provides IPv4 traceroute services between MPLS PE routers. The provider wants to implement IPv6 with MPLS 6PE/6VPE and then provide parallel IPv6 traceroute services between MPLS PE routers. Which two design solutions provide this service? (Choose two.) 

A. The P routers must support ICMPv6. 

B. The PE routers must support ICMPv6. 

C. The P routers must support full IPv6. 

D. The PE routers must support full IPv6. 

Answer: BD 


Q65. ACME Corporation is integrating IPv6 into their network, which relies heavily on multicast distribution of data. Which two IPv6 integration technologies support IPv6 multicast? (Choose two.) 

A. 6VPE 

B. 6PE 

C. dual stack 

D. ISATAP 

E. 6to4 

F. IPv6INIP 

Answer: CF 


Renovate testking 352-001:

Q66. You have been hired by Acme Corporation to evaluate their existing network and determine if the current network design is secure enough to prevent man-in-the-middle attacks. When evaluating the network, which switch security option should you investigate to ensure that authorized ARP responses take place according to known IP-to-MAC address mapping? 

A. ARP rate limiting 

B. DHCP snooping 

C. Dynamic ARP Inspections 

D. IP Source Guard 

Answer:


Q67. Refer to the exhibit. 

Acme Corporation hired you as a network designer to upgrade their network so that it supports IPv4 and IPv6 multicast. Which two protocols are needed on the LAN switch? (Choose two.) 

A. PIM sparse mode 

B. IGMP snooping 

C. PIM snooping 

D. Source Specific Multicast 

E. MLD snooping 

Answer: BE 


Q68. A service provider creates a network design that runs MPLS in its WAN backbone using OSPF as the IGP routing protocol. What would be two effects of additionally implementing MPLS-TE? (Choose two.) 

A. MPLS-TE is required to reroute traffic within less than 1 second in case of a link failure inside the backbone. 

B. MPLS-TE is required to route different MPLS QoS service classes through different paths. 

C. MPLS-TE and OSPF cannot be used together inside one MPLS network. 

D. MPLS-TE cannot use OSPF for the traffic path calculation. 

E. MPLS-TE is required to create backup paths independently from the IGP. 

Answer: B,E 


Q69. What are two benefits of following a structured hierarchical and modular design? (Choose two.) 

A. Each component can be designed independently for its role. 

B. Each component can be managed independently based on its role. 

C. Each component can be funded by different organizations based on its role. 

D. Each component can support multiple roles based on the requirements. 

E. Each component can provide redundancy for applications and services. 

Answer: AB 


Q70. Refer to the exhibit. 

In the DWDM network, a ring topology carries multiple services between two sites. Which option describes the employed protection design? 

A. Y-cable protection 

B. Splitter protection 

C. Client protection 

D. UDLD 

E. FEC protection 

Answer: