Proper study guides for Up to date Cisco CCIE SP Written v4.0 certified begins with Cisco 400-201 preparation products which designed to deliver the 100% Correct 400-201 questions by making you pass the 400-201 test at your first time. Try the free 400-201 demo right now.
Q101. Which network interface technology eliminates the need for an external transponder at service provider sites?
Q102. What is the main advantage of H-VPLS over VPLS?
A. H-VPLS provides redundancy.
B. H-VPLS provides security.
C. H-VPLS improves the scalability.
D. H-VPLS allows a broader use of protocols.
Q103. Which BGP feature improves the convergence and response time to adjacency changes with BGP neighbors?
A. Fast Peering Session Deactivation
B. BGP Multihop
C. reducing BGP scanner timing to the minimum that is supported
D. TTL Security Check
E. Next-Hop Address Tracking
Q104. Two routers that are running MPLS and LDP have multiple links that than connect them to each other. An engineer wants to ensure that the label bindings are not flushed from the LIB if one of the links fails. Which configuration meets this requirement?
A. the mpls ldp neighbor targeted command
B. the mpls ip command on a Cisco MPLS TE tunnel
C. the mpls ldp discovery targeted-hello accept command
D. the mpls ldp session protection command
Q105. An engineer has just configured IOS-XR with out-of-band MPP. Which are the three results that will occur? (Choose three.)
A. Management traffic to RP from all non-MPP interfaces is dropped
B. RP/DRP Ethernet Interfaces are not default out-of-band interfaces.
C. MPP configuration changes doesn’t affect active sessions established before the changes
D. Interfaces configured for out-of-band MPP are still part of global routing/forwarding
E. If MPP is disabled and a protocol is activated, all interfaces cannot pass traffic
F. LPTS will provide rate limiting
Q106. Refer to the exhibit. How will the redistributed routes on R1 from EIGRP into OSPF be installed in the R4 routing table?
A. as a default route with an E2 route type
B. as a default route with an IA route type
C. as specific routes with an E2 route type
D. as specific routes with an N2 route type
E. as a default route with an N2 route type
Explanation: http://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/6208-nssa.html http://www.cisco.com/image/gif/paws/6208/nssa.pdf
Q107. What are three main characteristics of mLDP that differ from RSVP-TE? (Choose three.)
A. The LSPs are built from tailend to headend.
B. The LSPs are built from headend to tailend.
C. It supports only P2MP LSPs.
D. It supports both P2MP and MP2MP LSPs.
E. Signaling is periodic.
F. No periodic signaling is performed.
Q108. What is NETCONF?
A. It is a standard for installing, manipulating and deleting configuration of network devices.
B. it is a Cisco proprietary solution to help remove the time, cost and manual steps involved in network element configuration.
C. It is data modeling language, to help remove the time, cost and manual steps involved in network element configuration.
D. It is a new recommendation which writes device specific CLI scripts while keeping flexibility in a vendor dependence environment.
Q109. In a routing virtualization concept, which are the two main techniques for creating vitalized router entities as defined by their physical and operational characteristics? (Choose two.)
Q110. Refer to the exhibit. Why is R3 unable to install 18.104.22.168/32 in its routing table?
A. 22.214.171.124/32 exists in the routing table, so the conditional advertising is not working.
B. The route is filtered out by the ip prefix-list ROUTE-IN command.
C. 126.96.36.199/32 is advertising in the BGP table, so conditional advertising is not working.
D. The bgp redistribute-internal command is missing under the R2 BGP process.